The 1" head cleaner is thin, like its longer counterpart, but not flexible-lending its use to tight areas that require consistent thinness but no flexibility or taper. The large and small chisel heads fit in between grille and wheel components, while the cone/pick head is the right tool for getting into and around bolts. When used as directed, Slick Stixxx automobile detailing tools are safe to use on chrome, billet aluminum, powder coating and painted surfaces. Directions and Recommendations Select the component head appropriate for cleaning the desired area and attach it to the handle of your choice. Use the included ferrule connectors if you wish to extend and customize the handle length or angle. You can also use the 45-degree and 90-degree component handles as butt-end handle grips for additional leverage or comfort. Always attach a butt-end cap to the non-working side of the handle. This will keep the end of the handle from accidentally scratching any surfaces. Wrap the supplied cloth around the selected cleaning head and handle combination, and then give the tool a twist to lock the rag on to the cleaning head. Next, apply cleaner or polish to the cloth. Use one hand to hold the tool and the other hand to hold the cleaning cloth, helping to articulate the tool in and around the desired area. As the cloth becomes soiled, move the cleaning head to a clean part of the cloth, apply more cleaner or polish, and continue. You can also put cleaning heads on both sides of a handle in lieu of a butt-end cap. This allows you to easily flip back and forth between either cleaning head, and makes the unit function like a "dental tool". The cleaning heads can also be ground down with a grinder or belt sander to fit your particular needs. Slick Stixxx are designed for use only with microfiber or other cloth material wrapped around the component ends. There may be certain applications-such as very dirty areas-that will require doubling the cloth, or the use of a thicker cloth. Cleaning cloths will wear down, and users should inspect them for holes and thinning before each use. Replace worn cloths as needed. Wrinkle-finish surfaces are particularly rough on both cleaning cloths and Slick Stixxx component heads. Extreme care should be taken to continuously monitor the condition of the cleaning cloth, and frequent inspections for holes and thinning are required for safe operation. If the component cleaning tip breaks through the cloth you are using, there is a chance that it could mark the wrinkle finish or billet aluminum. In the event that the tip breaks through, stop cleaning and move the component end to a fresh area of the cloth before resuming. Slick Stixxx components are designed to clean a wide variety of close-quarter surfaces What's In The Box? Each kit includes the following components, which have been numbered for identification in the image to the right. (1) 12" Straight Handle (2) 6" Straight Handle (3) 6" 45-Degree Handle (4) 6" 90-Degree Handle (5) 1" Head Cleaner (6) 4-1/4" Head Cleaner (7) 1" Chisel Cleaner (8) 3/4" Paddle Cleaner (9) 1/2" Chisel Cleaner (10) Cone/Pick Cleaner (11) Ball Head Cleaner (12) 2 Component Ferrule Connectors (13) 2 Component Butt-End Caps (ferrule connectors and butt-end caps can also be used as component cleaning heads) (14) Storage Bag and Cleaning Cloth.

Stains, scratches, swirls, tough water spots, and oxidation are no match for #2 Fine Cut Cleaner!.

Allow it to dry for 24 hours and then follow with a coat of Renovo Fabric Ultra Proofer to protect and prolong the life of your new looking top. DO NOT use on vinyl or vinyl impregnated fabric tops. When in doubt, consult the manufacturer. The 1Liter bottle will normally cover the average top with two coats.